Aerobed Adventure Bed Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Möbel Aerobed Adventure Bed herunter. AeroBed Adventure Bed User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
7991 Rev 11/09
128 Battery Pump
Flashlight
Instruction Manual
INFLATION
NOTE: BED MUST BE AT ROOM TEMPERATURE PRIOR TO INFLATING OR IT MAY CAUSE AIR LEAKS.
1. Place your rolled-up bed on the floor or other surface free of obstructions or sharp objects.
2. Remove protective cap on valve by turning cap counter-clockwise (see figure B). Locate inflation port located at the front of the pump (see figure C).
3. Press mouth of inflation port into position and turn pump to on position.
4. Press the switch to on position (the symbol “ - ” on the switch means “ON”).
5. In approximately 60 seconds, your bed will be inflated to the firmest capacity. Press switch to off position (the symbol “ o ” on the switch means “OFF”).
6. Detach pump and replace protective valve cap by turning clockwise.
To use pump with C-Cell batteries:
a)
Remove pump from protective plastic shipping wraps.
b) Remove battery cover located at the back of the pump. Pull yellow lever up to “open” and pull cap. NOTE: Cap is attached on one side of pump;
Do NOT pull completely off pump.
c) Insert eight new C-cell alkaline batteries (NOT INCLUDED). Make certain the batteries are installed correctly (see figure A).
d) Replace battery cover by pushing lever down to “close” on back of pump.
BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY.
To use flashlight:
NOTE: Batteries must be installed correctly in order to use flashlight. Flashlight will not work with 12-volt DC adapter.
a) To turn on flashlight, press yellow button on top of pump. To turn off flashlight, depress yellow button.
b) Flashlight will not work while pump is running.
IMPORTANT: Flashlight contains three energy saving LED bulbs which are NOT replaceable. To prolong life of your flashlight, turn off when not in use.
DEFLATION
1. Open valve cover and press rubber flapper inside valve to release air (see figure B).
2. Fold sides of bed into the center along its length (see figure E). Tightly roll your bed towards the valve to fully remove any excess air.
3. Roll the bed completely until all the air is expelled. When the bed is completely rolled, replace the valve cover.
4. For most compact storage, insert deflation port of pump into valve opening (see figure D). Press the switch on for deflation. Bed will expel
remaining air. Turn pump off once air is released, press the switch off to stop.
5. Slide the storage bag over your bed. Store your bed and pump until its next use.
UNIVERSAL ADAPTERS
For use with other air-filled products.
1. Attach universal adapter to end of pump by pushing until adapter locks into position.
2. Additional adapters are included for use with multiple sized valve openings.
3. Use pump with other products.
4. Discharge pump and store for next use.
A REPAIR PATCH CAN BE ORDERED AT WWW.AEROBED.COM OR BY CALLING OUR CUSTOMER SERVICE AT 1-888-462-4468.
READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
IMPORTANT: Preparation of your AeroBed product requires no tools. Use of tools may damage your bed.
WARNING:
This is an electrical product – not a toy. To avoid risk of fire, burns, injury, or shock:
- Unplug from outlet when not in use.
- Close supervision is necessary when this product is used by or near children, invalids, or disabled persons.
- Use this product only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
- Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water.
- Keep the cord away from heated surfaces.
- Never operate the product with the air openings blocked. Keep the air openings free of lint, hair, and the like.
- Never drop or insert any object into any opening.
WARNING: Product is for indoor use only. For household / residential use only.
WARNING: This furnishing has not been evaluated for flammability or cigarette ignition resistance.
ADDITIONAL WARNINGS:
- This is not a water toy. Use as a mattress only.
- This bed is not designed for use by children under 3 years of age or any persons with limited mobility as they could suffer serious or fatal injury through suffocation,
falling from or rolling off the bed or becoming trapped.
- Use on flat surfaces only. Bed may tip over on uneven surfaces.
- Inflate bed fully. Partially inflated mattresses can cause suffocation.
- Remove all sharp objects from area where bed will be set up and used. Do not use this bed on abrasive surfaces or near pointed/sharp
items or surfaces. Bed may puncture.
- Do not step or jump on bed or use as a trampoline.
- This bed is made of plastic and therefore may melt or burn if it comes in contact with any flame or heat source. Do not place it near or
against heaters, open flame, or other hot objects.
- Pump is not intended for continuous use. Pump may stop working or overheat if it is used for extended periods of time.
- Do not attempt to disassemble, repair, or service the pump. No serviceable parts are contained inside. Contact Aero Products International, Inc.
at 1834 Walden Office Square, Third Floor, Schaumburg, IL 60173, 1-888-462-4468 for repair or servicing information.
SAVE THESE INSTRUCTIONS.
Thank you for joining the AeroBed
®
family by purchasing one of our products. You can expect top-notch quality, innovation and imagination from every AeroBed product.
You are about to enjoy the comfort of an AeroBed product. It is your responsibility to read and always follow the safety, care and maintenance instructions for your new
AeroBed product. Always instruct and supervise others on your bed’s proper use, maintenance and safety.
Battery
Compartment (Insert Batteries as Shown)
A
B
Deation
D
Ination
Port
C
E
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - Instruction Manual

7991 Rev 11/09128 Battery PumpFlashlightInstruction ManualINFLATIONNOTE: BED MUST BE AT ROOM TEMPERATURE PRIOR TO INFLATING OR IT MAY CAUSE AIR LEAKS.

Seite 2

LIMITED EXPRESS WARRANTYAero Products International, Inc. (“us”) warrants to the original purchaser (“you”) that the AeroBed (“product”) is guaranteed

Kommentare zu diesen Handbüchern

Keine Kommentare